Connect Your Bitaxe to Parasite Pool
Point your Bitaxe at Parasite Pool (parasite.wtf:42069), a beta pool with an unusual payout: 1 BTC to the block finder, the rest split over Lightning.
Parasite Pool is a beta Bitcoin mining pool aimed at small miners. The site and dashboard are at parasite.space; the stratum host is parasite.wtf, which resolves to a server in Singapore (IP lookup). The payout is unusual: according to the founder’s launch post, nothing is paid until the pool finds a block, the finder gets a fixed 1 BTC, and the rest of the reward plus fees is split among the other miners by hashrate over Lightning. Treat these terms as the founder’s description, not a guarantee.
If you just want the standard solo experience from an Australian endpoint, use the ausolo guide instead.
This guide walks through the exact steps to configure your Bitaxe via AxeOS in about 15 minutes. You’ll end up with your miner connected, shares being accepted, and a clear picture of what “pooled mining on a Bitaxe” actually means for your electricity bill and payout expectations.
What you’ll need
- A Bitaxe miner, any model (Gamma 601/602, Ultra, Supra, Hex, etc.)
- A 5V DC power supply with a 5.5 x 2.1 mm barrel plug (the one supplied with your Bitaxe; 5A or more)
- A computer or phone on the same Wi-Fi network as your Bitaxe
- A Bitcoin address you control, in a wallet that can sign messages (BIP322)
Step 1, Choose your payout address
This is the most important step in the whole guide. Your Bitcoin address is your identity on Parasite Pool. You enter it in the username field and connect the same address on parasite.space by signing a message.
Hardware wallet (recommended): Generate a receive address from a Coldcard, Jade, Foundation Passport, or similar. This means your mining rewards land in cold storage from the first payout. Pick one address and stick with it, because the pool tracks your shares by address.
Hot wallet: A Sparrow wallet, Electrum, or similar software wallet is fine for testing or casual mining. Just make sure you have your seed phrase backed up offline before pointing a live miner at it.
Warning: Do not use an exchange deposit address. Exchanges frequently recycle or expire deposit addresses, and on-chain payouts sent to a recycled address may be lost.
Step 2, Find your Bitaxe’s IP address
Power on your Bitaxe and wait about 60 seconds for it to connect to your Wi-Fi network. Then find its IP address using one of these methods:
- Router admin page: Log into your home router (typically
192.168.1.1or192.168.0.1) and look for a device calledbitaxeorESP32in the connected devices list. - mDNS: On Mac or Linux, try
http://bitaxe.localdirectly in your browser, it often resolves automatically. - Network scanner: Apps like “Fing” (iOS/Android) will list all devices on your network with their IP addresses.
Step 3, Open AxeOS in your browser
Type your Bitaxe’s IP address into your browser’s address bar. You’ll see the AxeOS web interface, a dark-themed dashboard showing hashrate, temperature, and current pool settings.
http://192.168.1.XXX
Replace XXX with your Bitaxe’s actual last octet. No password is required for AxeOS by default.
Step 4, Navigate to Settings
In AxeOS, open the Pool page from the left-hand menu. This is where you enter the pool details (Primary Pool, with an optional Fallback Pool).
Step 5, Enter the Parasite Pool stratum URL and port
AxeOS uses two separate fields:
- Stratum Host:
parasite.wtf - Stratum Port:
42069
If your miner takes a single URL instead, use:
stratum+tcp://parasite.wtf:42069
Tip:
parasite.wtfis the mining endpoint.parasite.spaceis the website and dashboard. Openinghttps://parasite.wtfin a browser shows a certificate warning (the certificate is forsin.parasite.wtf); this does not affectstratum+tcp.
Step 6, Set your username (wallet address + worker name)
In the User field, enter your Bitcoin address followed by a dot and a short worker name of your choosing:
bc1qYOURADDRESSHERE.bitaxe1
The format is:
BTC_ADDRESS.WORKER_NAME
For example:
bc1qnotarealaddress.steveMiner
bc1qnotarealaddress.jillAxe
The worker name is optional but useful if you’re running multiple Bitaxes, it lets you distinguish them on the parasite.space stats page when you enter your address. Keep it short, lowercase, and alphanumeric (no spaces or special characters).
Step 7, Enter any password
In the Password field, type anything:
x
Parasite Pool does not check the password field at all. x is convention across most pools that ignore it.
Step 8, Save and restart
Click Save, then Restart. AxeOS will restart the miner process and begin connecting to parasite.wtf:42069.
Step 9, Verify shares are being accepted
After the restart, watch the AxeOS dashboard. Within 2–5 minutes you should see:
- Best Share or Last Share updating, this means the pool accepted a share from your miner.
- Hashrate settling to your expected figure (about 500 GH/s to 1.2 TH/s depending on model and tuning).
If you don’t see shares accepted after 5 minutes, jump to the Troubleshooting section below.
Step 10: Check your stats on parasite.space
Open parasite.space in a browser and paste your Bitcoin address into the search bar at the top. You’ll see your worker’s hashrate, shares submitted, and historical performance.
To receive payouts you also need to connect your wallet on parasite.space and sign a message. Lightning payout setup is described differently in different guides, so follow the steps on parasite.space rather than this guide.
A realistic note on earnings
A single Bitaxe Gamma 601 runs at roughly 1.2 TH/s against roughly 1,000 EH/s of global network hashrate. On the founder’s description, the pool pays out only after it finds a block, and the finder takes 1 BTC. Your return depends on the pool’s block-finding frequency and on whether the terms hold as described. Do not plan around it. Work out your own electricity cost from your tariff and compare.
If you want the plain solo experience, see the ausolo ckpool guide.
Troubleshooting
Miner shows “Connecting…” but never gets shares accepted
Check that you’ve used parasite.wtf (not parasite.space) as the host, and that the port is 42069. Some routers block unusual outbound ports, try switching to a different network or checking your router’s firewall settings.
AxeOS shows wrong hashrate or keeps restarting This is usually a power supply issue. The Bitaxe needs more than 4A at a steady 5V, so try a 5V 5A to 6A supply. Overclocking in AxeOS can also cause instability; set frequency and core voltage back to the preset values on the Settings page.
My address doesn’t appear on parasite.space Give it some time after your first accepted share. The stats page updates periodically. Make sure you’re pasting your address exactly as entered in AxeOS, any typo means a different (empty) account.
The pool keeps dropping connections Your home internet may be adding latency or packet loss. Try setting a fallback pool on the Pool page. The public pool guide lists options.
I entered an exchange address by mistake Stop the miner immediately and update the address in AxeOS. Shares submitted before the change may be credited to the old address. Use your own wallet address going forward.
What’s next
- Go solo: For plain solo mining (a 2% fee, taken only if you win a block), see Connect Your Bitaxe to ausolo.ckpool.org.
- Try a bigger pool: If you want access to more stratum options or redundancy, connecting to a major public pool covers Braiins, Ocean, and others.
- Get a Bitaxe: Don’t have one yet? Browse the Bitaxe range at Shop Bitcoin Australia.
Frequently Asked Questions
What is Parasite Pool and who runs it?
Parasite Pool was launched by the founder known as ZK Shark (creator of Ordinal Maxi Biz), with infrastructure credited to Sati. It is in beta. The stratum host parasite.wtf resolves to a server in Singapore. The site and dashboard are at parasite.space.
How does the payout work?
It is not plain solo and not a standard proportional pool. The launch post describes an event-driven model: nothing is paid until the pool finds a block, the miner who finds it gets a fixed 1 BTC, and the rest of the reward plus fees is split among the other miners by hashrate over Lightning (10 sat threshold). The pool's own site does not state these terms, so confirm them before relying on them.
What are Parasite Pool's fees?
Zero, according to the founder's launch post.
Has the pool found blocks?
Phemex reported a second block (height 945,601) in April 2026, about 48 days after the first. The pool is still described as beta, and the launch post says there is no assurance of future blocks or payouts.
Should I use a hot wallet or hardware wallet address?
The pool asks you to connect a wallet on parasite.space and sign a message (BIP322), so use a wallet that supports message signing. Do not reuse a wallet that holds significant funds or Ordinals while you are testing a beta pool.
What should I enter in the Password field?
Leave the default or enter 'x'. A third-party guide says the password is not used.